Stingl GmbH
Dimbacher Straße 25
74182 Obersulm-Willsbach

07134 / 13797-11


Stingl Systems GmbH
Dimbacher Strasse 25
D-74182 Obersulm-Willsbach

+49 7134 13797-11


Assembly-friendly shaft wall cladding

Article LIFTjournal edition 03/2020

Assembly-friendly shaft wall cladding 

Stingl has developed a product to meet the requirements of EN81-20 an assembly-friendly shaft wall cladding made of flame-resistant rigid foam panels. ... 

by Stingl GmbH

Product catalog

Overload Control System WeightWatcher light MULTIROPE

Overload Control System
WeightWatcher light MULTIROPE

WeightWatcher light Multirope
WeightWatcher light Multirope

For the development of the latest product of the WeightWatcher Light series, the MultiRope measuring system, our development division could rely on the knowhow gathered over many years. Great store was set by the ease of installation and the request put forward by many customers to provide a reasonably priced but high-quality overload measuring system which meets the requirements of EN 81. The applications in the range of 4 to 26 mm rope diameters also meet the requirements. Measuring ranges of up to max. 10,000 kg (optional for Multirope 300) allow a wide variety of applications.


  • two types of sensor for 200 and 300 mm clamping widths
  • for 4 to 26 mm rope diameters
  • measuring range up to 10,000 kg
  • 2 freely programmable output relays
  • integrated evaluation unit

Method of function:
Only a few minutes are needed to install the MultiRope sensors: The installation only requires the screws of the retaining strap to be loosened and the sensor to be put against the rope. The retaining strap is then closed again and the screws are tightened up until the rope is pressed against the sensor body.

A specific tightening torque must not be applied. No special tools are required. Thanks to the integrated evaluation unit no additional cables are needed to connect the sensor and evaluation unit.

The unit can be configured using three keys and the 4-digit LED display. The unit is connected to the control system by means of 2 freely programmable alarm relays. After the MultiRope sensor has been calibrated, the evaluation unit displays the lift car load. As soon as the parameters for the 3 output relays are entered using the built-in keys the unit is ready for operation.

Product overview
Ite No. Description
68200456600 Mulitrope 200
68200456700 Multirope 300
68200456605 Mulitrope 200 CANopen
68200456705 Multirope 300 CANopen
Copyright © 2020 Stingl GmbH
This website uses cookies to provide the best possible functionality.
By using this offer, you agree that we may leave cookies on your computer. More information...